Promag CON-485 Series Instruções de Operação Página 65

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 98
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 64
Memo-Graph S 6 Guaranteeing the requirements of 21 CFR 11
Endress+Hauser 65
6.3.2 Activating the automatic read-out function and autom. data sto-
rage
A reliable, fully functional interface connection between the device and the PC software is required.
This should be verified before activating automatic batch print-out.
Recommended: To automatically reactivate the automatic functions after a PC power supply fai-
lure, configure this in the set-up:
Æ Extras Æ Program options Æ Set up Æ Automatic (2) Æ Automatic Æ "automatically start after
x minutes“.
One-off initialisation phase for automatic read-out and data storage:
1. From the device list, select the device which should be read out automatically:
Æ Unit Æ Display/change unit set-up/add new unit
2. Read the current set-up into the PC:
Æ Unit set-up Æ New read out using interface (e.g. serial/modem/TCP(IP) and thereby
ensure the set-up matches the settings in the device data base in the PC.
3. Activate automatic read-out for this device:
Æ Extras Æ Set up automatic Æ Read out stored data Æ e.g. daily at 00:00. In this way, you
specify the device(s) which should be used for automatic read-out/print-out.
4. If necessary, configure the parameters for automatic data storage:
Æ Extras Æ Set up automatic Æ "Measured value data base maintenance“, e.g. "Save data to
data carrier“ function.
5. Then save the settings:
Æ FinishedÆ "Store set-up into unit data base"
Note: Where necessary, the data copied to the data carrier can also be archived on CD/back-
up tape etc. (depending on your archiving regulations).
Then activate the automatic function in the main program screen:
Æ Automatic Æ Start.
!
Note!
Automatic read-out of the device(s) starts at the time shown.
6.3.3 Activating the e-mail alarm
Any connection problems arising during automatic mode (see above) between the device and PC
software (e.g. line interrupted) can also be transmitted by e-mail, if necessary.
One-off initialisation phase for the e-mail function:
1. Make the appropriate server settings:
Æ Main menu Æ Extras Æ Program options Æ Set up Æ E-mail
2. Activate e-mail transmission:
Æ Main menu Æ Extras Æ Program options Æ Set up Æ Automatic (1) Æ "E-mail transmis-
sion of messages/fault messages received"
Note: If e-mails are to be sent to more than one recipient, the e-mail addresses must be sepa-
rated by a semicolon (e.g. [email protected];[email protected]). Your e-mail server/e-mail
provider is responsible for delivering the e-mails.
Then activate the automatic function in the main program screen:
Æ Automatic Æ Start.
!
Note!
Automatic read-out of the device(s) starts at the time shown.
Vista de página 64
1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 97 98

Comentários a estes Manuais

Sem comentários